Add multiple and/or custom voltage and hertz ratings

Replace existing motor nameplate with new nameplate with requested re-rate data (i.e. voltage, load, ambient temperature, etc.)

Provide an extra unmounted motor nameplate with requested specifications.

Install C-Face or D-Flange kit on NEMA motors

Install B5 (D-Flange) or B14 (C-Flange) on IEC motors

Convert F1 to F2, sidewall or ceiling mount

Add cast iron fan cover and/or junction box

Turn down the shaft from T to TS, or other required size

Extend the shaft length to specification

Drill and tap one hole in either end of the motor’s shaft or mill a flat on the drive end shaft extension

Threading

Change Ball Bearings to Roller Bearings and vice versa.

Change bearing type to a low temperature bearing.

Install insulated bearings.

Install sealed bearings.

Add space heaters

Add thermal protection (thermostat, RTD’s, PTC thermistor, etc.)

Add junction box for accessory leads

AEGIS ring installation

Bearing RTD’s

Install terminal block for NEMA or IEC Metric motor

Add constant velocity blower kit on NEMA (180-440 frame) 

or IEC (112-280 frame) motors

Install drip cover for NEMA or IEC Metric motor for outdoor shaft down applications.

Tap or provide additional lead hole

Rotate junction box lead opening

Add oversized cast iron junction box

Replace die cast aluminum junction box

Add junction box for thermal protection (thermostat, RTD, PTC thermistor, etc.) or space heater

Add anti-condensation drain holes at the lowest point of the motor, including holes recommended for vertical operation

Install “T” drain plugs

Close standard anti-condensation drain holes

Install terminal lugs

Reduction from (12) twelve leads to (6) six leads

Connect for high or low voltage

Add grounding screw on endplate or in a specified location

Custom colors available